8 axis automatic winding machine


图1大.jpgMechanical properties:
High quality resin sand casting
The base plate is welded with steel plate, bearing large, reducing noise and reducing noise, and increasing the stability of the machine.
Imported guide rail and screw, to ensure that the positioning of the machine and the accuracy of repeated positioning
Each step of the assembly of high speed spindle passes through strict quality control, high speed, low noise and long service life.
Type of replacement is convenient, need to invoke the appropriate procedures and support can replace the fixture
Frame detection devices in place can be detected is not in place of the skeleton, and timely alarm and shutdown, ensure that the needle was not interrupted
The needle rod adopts imported mold steel made of full length parallelism and perpendicularity <0.01mm, <0.01mm.
Main configuration:
1, using the Japanese servo motor, imported silk, guide rail.
2, using the Japanese SMC cylinder, Japan's small gold wells pneumatic solenoid valve.
3, using the Japanese Kean fiber sensor, Japan's OMRON photoelectric switch, Japan SMC magnetic switch.
4, the main shaft using the Japanese NSK high speed bearings, the use of Japan's Samsung belt.

Specification parameter

Spindle spacing

85mm

Number of principal axis

8

Spindle direction

Clockwise/counter clockwise/360

Control axis

4

Spindle speed

8000rpm

D stroke

X:85   Y:85   Z:55

Spindle servo motor power

1500W

Applicable line diameter

0.02~0.5(Increasing the power of the motor can be applied to larger diameter)

supply voltage

AC 220V±10%

power

2000W

Max frame outside diameter

77mm

compressed air

0.4~0.6mpa

Host size

1200mmX1000mmX1300mm

Host weight

800kg


















展开